The convenience of panel-mounting cables and non-terminated VGA in one amazing cable!
This cable uses our special spliced-VGA breakaway for easy routing, and terminates
to a panel-mount connector for installation on a faceplate or custom panel.
1151-CAP
VGA Spliced Cap For Conduit
EACH
$
14.95
10 in stock
1151-P
VGA Panel-Mount to DIN Stub
EACH
$
19.00
322 in stock
1154-10C
VGA Spliced Panel-Mount M/F
10 ft
$
39.00
43 in stock
1154-15C
VGA Spliced Panel-Mount M/F
15 ft
$
45.00
18 in stock
1154-20C
VGA Spliced Panel-Mount M/F
20 ft
$
50.00
5 in stock
1154-25C
VGA Spliced Panel-Mount M/F
25 ft
$
55.00
38 in stock
1154-30C
VGA Spliced Panel-Mount M/F
30 ft
$
59.00
9 in stock
1154-40C
VGA Spliced Panel-Mount M/F
40 ft
$
69.00
4 in stock
1154-50C
VGA Spliced Panel-Mount M/F
50 ft
$
79.00
5 in stock
1154-00C
VGA Spliced Panel-Mount M/F Custom build at $35.00 + $1.50 per foot.
Some custom products may not be REACH compliant.
1154-00P
PM-F/M VGA Spliced Cab PLENUM Custom build at $90.00 + $3.80 per foot.
Some custom products may not be REACH compliant.
The DataPro VGA panel-mount extension
cable is used to extend the length of a VGA,
XGA, or SVGA monitor cable, and is a non-terminated
cable for use in wire runs through conduit, walls, boats, etc. The pigtail end is panel-mount VGA, and can terminate on a bulkhead or wallplate.
The first piece of the set has a male VGA
connector and a locking male circular connector, available
in various lengths.
The second piece has a female circular
and a panel-mount female VGA connector, and measures approximately
18 inches long. Both parts are included when you order.
By splicing the two VGA connectors with the circular
connector, this cable can be run through
wiring holes as small as 0.75" (19mm). Once reassembled, the splice connectors screw-lock together for a tight and secure seal.
Splice connector fits through 3/4" conduit!
The cable is made of 75 Ohm video-grade
coaxial wire. This low-signal-loss cable
allows lengths of up to 200 feet in most
cases, with good signal strength.
We also offer spliced, non-terminated VGA cables in the following configurations:
Please note that the splice connector does not conduct the ID and DDC channels (pins 5 and 9) of the VGA signal. Most computer monitors have no issue with this, but some television and projector models cannot detect a signal without these channels.
The DataPro VGA panel-mount extension
cable is used to extend the length of a VGA,
XGA, or SVGA monitor cable, and is a non-terminated
cable for use in wire runs through conduit, walls, boats, etc. The pigtail end is panel-mount VGA, and can terminate on a bulkhead or wallplate.
Drawing (PDF)
Model (STEP)
